I am new to the forum and this topic has probably been beat to death. I apologize ahead of time.
77 stock L48
While in traffic (stop and go) I get a shudder. Temp gauge is only reading 200. I'm thinking tranny overheat/torque converter issues.
I am new to the forum and this topic has probably been beat to death. I apologize ahead of time.
77 stock L48
While in traffic (stop and go) I get a shudder. Temp gauge is only reading 200. I'm thinking tranny overheat/torque converter issues.
Is it only while you're sitting still, idling? Or as you're moving slowly?
-Adam Wartell
NCM Lifetime Member #1222
Founder: C3 Vette Registry
C4 Vette Registry, C6 Vette Registry
My first Vette, now owned by JB79:
Moving forward slowly. When I let off the brake it grinds and shudders. In normal driving conditions it feels fine.
Fluid is fine and a few months ago I dropped the pan and replaced the filter.
Moving forward slowly. When I let off the brake it grinds and shudders. In normal driving conditions it feels fine.
Fluid is fine and a few months ago I dropped the pan and replaced the filter.
Lotta questions, so here it goes...
1: Does it do the same thing in reverse?
2: Are you certain it is not a brake issue?
3: Does it ONLY do it in 1st gear?
4: Are you certain it is not a brake issue?
5: Does it only do it going straight, or when turning, or both?
6: Are you certain it is not a brake issue?
7: Are you certain it is not an engine miss?
8: Will it do it with the shifter in manual low?
9: Are you certain it is not a brake issue?
10: Have you checked the rear wheel bearings for play?
1st thought is a brake problem.
2nd thought is possibly the posi clutches binding.
3rd thought is an engine misfire/vacuum leak. Releasing the brake pedal when the booster diaphragm is cracked will cause a fairly large vacuum leak for a few seconds, causing the engine to run rough.
Lastly, it could be a flywheel issue, causing a vibration, and a grind/popping noise at times, especially at idle in gear..
It could possibly be a planetary issue in the transmission, but not likely. Planet issues will cause noises in 1st and second gears, but not 3rd, and make a lot of noise as well as in reverse.
400 transmissions and/or torque converters are not known for any kind of shudder problems. Did you have this issue BEFORE changing the fluid & filter? If not, did you replace the o-ring seal on the filter extension tube that fits up into the case?
Joel Adams
C3VR Lifetime Member #56
My Link
(click for Texas-sized view!) NCRS
"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"
Today it did it more. I was able to get to a quiet spot and open the door. It sometimes feels and sounds like it's coming from the tranny. Today sounded and felt more like rear end.
I replaced all the u joints but didn't repack the rear bearings or check the diff.
Things done a few months ago;
New water pump
Flush radiator
New dual timing chain
Rebuilt front end and 4 new shocks
Rebuilt original Quadrojet
New true dual exhaust
Removed all unnecessary emissions
Recurved distributor
New steering box
New brakes and rotors